Avionics Bay Assembly - Part2
A week or so later I had all of my parts back from the power coat shop and things could not look better.
Here is what the radio and intercom stack looked like before:
Here is the communications stack with a fresh coat of my favorite color.
Vertical Power module installed, and Rotax engine module bracket shown in top right.
Tip #1
This would be a good time to install the Rotax engine module if you have it, if not it can be completed later with much cursing and scraping of skin off of your hands.
Next I need to match drill the avionics bay doubler that is Clecod to the top rib as shown below.
Multiple M4/M5 rivnuts are installed that will be used later to install modules and batteries.
All Rivnuts are installed with J-B Weld Steel Reinforced Epoxy.
The lower row of holes are match drilled and then riveted when bottom tray is installed.
Nylon zip tie mounts are installed and ready for equipment installation.
